*****Configuration steps
1.
Select the ports
Add 2 ports in the
configuration and rename them as IGMP Host and Querier
2.
Enable IGMP protocol on the
ports
Click on Protocols on Protocol
tree and then switching to Multicast
tab
3.
Configure the IP addresses on the ports
IGMP Querier
IP=1.1.1.1
IGMP Host IP=1.1.1.100
You need to Add Interfaces and Add IPv4 addresses on the ports
Enable the interfaces, the port link should be green without exclamation mark
4.
IGMP Querier configuration
Go to IGMP on Protocol
tree and switch to Ports tab. Set
number of queriers to 1 Number of host to
0
On the Querier tab add the Connected Interface to
the Querier and enable it
Set the querier to use IGMPv3
5. Configure IGMP host:
Go to IGMP on Protocol
tree and switch to Ports tab. Set
number of queriers to 0 Number of host to
1
On the Hosts
tab add the Connected Interface and
enable it
On the Host
tab set No of Group Ranges to 1
Switch to Group Ranges
tab and set the multicast group for which the IGMP host is member
6. Start IGMP
*****Tools for troubleshooting
1.
Capture packets
Go to Captures button and enable control capture on ports. Click on Start Capture from Main ribbon
2. Use Port Trace Window:
On Protocol Tree right-click on a port and chose Open Trace Window. Select the level of debugging.
On Protocol Tree right-click on a port and chose Open Trace Window. Select the level of debugging.
In the Trace Window you see packets received and sent by the port
