IxNetwork NGPF : IGMP configuration

Scenario:

port1: 1 IGMP querier
         IP=1.1.1.1/24, GW=1.1.1.100, IGMPv2
port2: 10 IGMP host
          IP-1=1.1.1.100, GW=1.1.1.1, IGMPv2, Group =225.0.0.1
          IP-2=1.1.1.101, GW=1.1.1.1, IGMPv2, Group=225.0.0.2
          -----
          IP-10=1.1.1.109, GW=1.1.1.1, IGMPv2, Group=225.0.0.9


 Configuration

1. Create IGMP querier topology
Open IxNetwork, click  on Scenario button and then on New Topology button.
Append a port to New Topology and click Next

In select protocols choose IGMP Querier and click Finish
*** Is not necessary to chose IP also, IxNetwork will know to create the proper stack

The Result topology will look like this:

***by default 10 devices are added in the topology
 Change the device multiplier to 1 so that  just one IP will be used

2. Configure the IP address:
Click on IPv4 1 layer in device group
On the master pattern ( blue line ) click on IP address and chose single value and set it 1.1.1.1

On the master patterm click on GW and chose single values 1.1.1.100

3. Configure the IGMP settings
*** IGMP setting are located on IGMP Querier 1 layer. For this example the default value will work fine

4. Create  one IGMP host topology
click on new topology button, append  port2 and select protocol Igmp Host

5. Configure the IP addresses
click on IPv4-2 layer to see the IP settings
on master pattern chose IP address pattern to be increment  starting 1.1.1.100

on master pattern chose GW address to be singular values 1.1.1.1

6. Configure IGMP settings
click on IGMP Host2 layer
On group address master pattern make it incremental startin 225.0.0.1

7. Start all protocols from main ribbon

When all devices are up they appear green.